Waeco AirCon Service 6300G Operating Manual page 14

English
5. Enter the password
The company data is shown in the third line of the display.
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the message Enter company data (01 to
05).
Use the cursor keys
6. Use the keypad and the cursor keys to enter the data. To switch between upper and lower case, press the
key. To delete a character, briefly press the C key. To delete the current line, press and hold down the C
key.
7. Press ENTER to confirm.
8. Press STOP.
The set data is activated.
Press STOP again.
9.
The standby menu is displayed.
12.8 Entering the date and time
Date and time are required for logging of the service procedures. The date and the time are printed along with the
company data on every service log.
1.
In the basic menu use the cursor keys
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER to confirm.
3.
Use the cursor key
Press ENTER to confirm.
4.
5. Enter the password
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER to confirm.
8. Press STOP.
The standby menu is displayed.
12.9 Editing default values
The A/C service unit has preset values for the most important service tasks. The default values appear
automatically when you select the respective menu.
You can alter the following default values if necessary:
Parameter
Pressure increase test time min.
Vacuum time min.
Leak test min.
PAG oil ml. (additional quantity)
UV tracer ml.
Filling Qt. g.
12
.
3282
or to select the line of company data you want.
or
to select Service.
.
8463
to select Other selections.
Default value
1
1
4
0
0
500