Troubleshooting - Promeba PB-410 Series User Manual

USER GUIDE // STRETCHER SUPPORT SERIES PB-410
Review 2022/01
03
OPERATION
03.3.4 EXTRA LONGITUDINAL DISPLACEMENT (ONLY FOR PB410/3)
The PB410/3 stretcher support allows for a longitudinal movement of 360mm to facilitate the movement of
health technicians inside the ambulance.
To carry out this movement, you must locate the lever that is placed at the rear of the right side of the stret-
cher support (according to the direction of the ambulance).
Activate the lever with your hand and accompany the movement by pushing or pulling longitudinally the
platform. Release the lever and continue to move the platform until the carriage is locked in one of the 2
positions (forward or rear).
ATTENTION: Before placing the base in the loading position, move the platform back to its
original position, without the extra longitudinal movement.
03.3.5 SCOOP STRETCHER FIXATION (ONLY FOR PB410, PB410/3 AND PB410/6)
The PB410, PB410/3 and PB410/6 stretcher supports have accommodation for a scoop stretcher.
Follow the steps below for proper attachment and removal:
To place it, the scoop stretcher must be slid upside down on the base tray. Gently push it until it is in contact
with the front retaining clips. Push it harder against the retaining clips until it is anchored.
To extract the scoop stretcher from the accommodation, hold it with both hands and pull it hard until it
disengages from the clamps. Keep pulling it by sliding it along the base tray until it is completely removed.
03.3.6 SCOOP STRETCHER AND SPINAL BOARD FIXATION (ONLY FOR PB410/4)
The PB410/4 stretcher support has double accommodation for a scoop stretcher and a spinal board.
Follow the steps below for proper attachment and removal:
Take the spinal board together with the scoop stretcher and slide them onto the bed tray. Push them along
the tray until they are in contact with the front stop.
In the central part of the bench you will find a belt that you must fasten around the spinal board and the
scoop stretcher. You will find another belt at the front of the bench that you must pass through the tube of
the scoop stretcher and one of the holes in the spine board and fasten it. Adjust the belts well so that both
products are well secured and thus avoid noise during transport.
To remove the scoop stretcher and the spinal board from the accommodation, unfasten the two belts. Hold
both products together with both hands and pull them out by sliding them along the base tray until they
are completely removed.
03.4

Troubleshooting

PROBLEM
Structural damage
When tilting the platform, it does
not lock
The lock lever does not return to
its position.
When activating the controls,
the shelf does not unlock the
movement
CAUSE
Improper use or operators not properly trained
The tilt lock system is damaged or the cables
have lost tension and are not actuating properly.
The spring is damaged
The cables are not tight enough
SOLUTION
Take the stretcher support out of service imme-
diately and contact the technical service
Check system cables and sheaths.
If no anomaly is perceived and the problem
persists, contact the technical service.
Replace spring.
If the problem persists, contact the technical
service.
Tighten the cables with the tensioners.
If the problem persists, contact the technical
service.
21