Table of Contents
Advertisement
Installation, cont'd
Routing the AAP Cables
The AAP cables must have freedom of movement to permit
opening and closing the surface mount enclosure. At the same
time, they need to be restrained to prevent them from rubbing
against the edges of the enclosure cable access hole in the
underside of the surface mount enclosure. Rubbing against the
cable access hole edges can damage the cables. Route and
secure the AAP cables as follows:
Connect the enclosure to the appropriate power source:
1.
•
125 VAC, 60 Hz, 5 A (US domestic version)
•
220-240 V, 50/60 Hz, 5 A (international versions)
2.
Press on the surface block to open the top panel and
extend the AAP cables to their maximum pull.
3.
To prevent wear and tear or binding of the movement
caused by cable movement, secure the AAP cables inside
the enclosure. Use tie wraps to secure the cables to the tie-
downs accessible through the cable access holes on the
underside of the HSA (figure 2-14).
4.
On the underside of the HSA, remove the
jumper from the 10 pin control and status
captive screw connector.
2-16
HSA 822MS • Installation
Figure 2-14 — Cable tie-downs inside the HSA
(seen from underneath)
HSA 822MS • Installation
2-17
Advertisement
Table of Contents
