Table of Contents
Advertisement
Packaging for Shipment, Cont'd
Remove two
screws ea. side.
Remove panel.
Replacement Face Plate
Screws (4) under Enclosure
Figure B-3 — Removing the AAP/RJ-45 panel
The center screws on each side of the AAP/RJ-45 panel
do not fasten the AAP/RJ-45 panel in place. They secure
the AC power outlet.
Ensure that the edges of the AAP/RJ-45 panels do
CAUTION
not scratch the finish of the furniture in which the
HSA 822MS is installed when removing the panels.
d.
Remove the two bolts and washers that secure the
tray to the underside of the HSA and remove the tray.
e.
Disconnect any cables from the rear of the existing
AAPs. From the underside of the enclosure, reach
into the cable access holes (figure 3-1 on page 3-2,
item
), and cut the tie wraps (
3
downs) that route the AAP cables inside the
enclosure. Carefully pull the cables through and out
the bottom of the HSA.
f.
Remove the AAP(s) that you intend to keep from the
AAP/RJ-45 panels by unscrewing the nuts on the
rear of the AAP/RJ-45 panels that secure the AAPs in
place (figure B-4).
B-4
HSA 822MS • Packaging for Shipment
HS
A 82
2
shows the tie-
5
#4-40 Nut w/ Captive
AAP/RJ-45
Panel
H S
IN P
U T
S E
L E
C T
C O
A U
M P
D IO
U T
E R
RGB 580xi SI AAP
Figure B-4 — Mounting an AAP device
g.
Use the two bolts and washers that you removed in
step d to reinstall the tray to the underside of HSA.
h.
Remove and retain the four 1/4" nuts that secure the
top plate to the lifting plate (figure B-5) and remove
the plate.
Figure B-5 — Location of the top plate nuts
HSA 822MS • Packaging for Shipment
Washer
Cable
A 8
2 2 M
S
B-5
Advertisement
Table of Contents
