Table of Contents
Advertisement
Installation and start up
4.12 Normal start
membraPure GmbH
Wolfgang-Küntscher-Str.14
16761 Hennigsdorf
Germany
The system prompts to turn on the submersible lamp and
install the sterile filter.
Turn on the submersible lamp by plugging the power
-
adapter into an electrical outlet
Install the sterile filter (see chapter 4.9).
The system is in normal operation and fully operational now.
At first water dispensing please open the deaeration
-
screw for a short time to vent the sterile filter (see
Figure 13: sterile filter).
Finally do system time correction (see Chapter 5.4.2)
Discard after short-term interruption (eg weekend) the first
100ml of water abstracted
This is the first display after connecting to the mains.
-
The system jumps to the start screen.
If „Skip" is selected the system starts the normal
-
operation mode immediately.
This first display is only recallable through a reset
-
function which is implemented in the control.
Tel.: +49 (0) 3302/201-20 0
Fax.: +49 (0) 03302/201-20 21
E-Mail: info@membrapure.de
Internet: www.membrapure.de
page 24
Advertisement
Table of Contents
