System Control Panel; Normal Operation Mode; Tools; Changing The Consumables - MP Aquinity2 P10 User Manual

System Control Panel

5 System Control Panel
5.1

Normal operation mode

If the Aquinity² P10 is connected to power supply, the system jumps in normal operation
mode automatically. By default, the main information screen is displayed. The entire
process is fully automatic controlled.
Main information
screen

Tools

History
User setup
5.2 Tools
The "Tools" selection contains functions for changing consumables and for process
visualization.
5.2.1

Changing the consumables

These following steps are used to change either ProPak or UPW-Pak. The steps are similar
for both consumables. But they have different internal process which runs automatically.
Conductivity permeat
Figure 12: Main information screen Aquinity² P10
Press the button "CHANGE ProPak" or
-
press the button "CHANGE UPW-Pak"
Tank level should be full to change the UPW-Pak. If tank
level is not full, the tool aborts automatically.
Ultra pure water
conductivity and
temperature
Tank level
Status bar
19