Installation And Start Up; Feed Water Requirements - MP Aquinity 2 E Service Manual

Installation and start up

There are eight magnetic holders (4 each side) to hold the panel which covers both side of
the system. This side panel could be opened when it is needed in order to change
consumables.
4 Installation and start up

4.1 Feed water requirements

All given flow rates are based on feed water temperature of 10°C (50°F). The RO permeate
flow will change approx. 2% for each °C (decrease for lower values, increase for higher
values).
pressure
max. Flow
feed water conductivity
free chlorine
CO
2
silica
Silt Density Index (SDI)
iron
manganese
pH
temperature
membraPure GmbH
Wolfgang-Küntscher-Str.14
16761 Hennigsdorf
Germany
Figure 9: Side panel with magnetic holder
bar
L/h
µS/cm
mg/L
mg/l
mg/l
mg/l
mg/l
°C
Table 3: Feed water requirements
Tel.: +49 (0) 3302/201-20 0
Fax.: +49 (0) 03302/201-20 21
E-Mail: info@membrapure.de
Internet: www.membrapure.de
1,5 ... 6
80
< 1400
< 0,1
< 15 concentration total
< 10
< 3
< 0,1
< 0,05
3 ... 9
5 ... 25
< 20
page 17