Figure 2-5: 7880Ip-Asi-Ip Hyperterminal Main Menu - evertz 7880IP-ASI-IP Manual

7700/7800 MultiFrame Manual
7880IP-ASI-IP IP/ASI/IP Converter
Click OK to apply these settings and press the enter button on your keyboard. The card Main Menu
should appear as shown in Figure 2-5:

Figure 2-5: 7880IP-ASI-IP HyperTerminal Main Menu

(1) Control Network Configuration
This sub-menu enables the user to configure the control network settings. The Configuring this sub-
menu allows the user to access the card through the VLPro Client interface.
(2) Data Network Configuration
This sub-menu enables the user to configure the data port network settings. This setup can
alternatively be completed from VLPro once the control network settings have been established.
(3) SNMP Configuration
This sub-menu enables the user to configure the Simple Network Management Protocol settings. In
this menu you can set or remove the SNMP trap IP address and the SNMP Read and Set community
strings.
(4) Debug Interface
This menu is for Evertz personnel only. You may be requested to access and execute options within
this menu when seeking technical support from Evertz. Guidance will be given should this be required.
Before is it possible to configure the card via VLPro it is first necessary to configure the initial basic
network settings via the serial cable. Refer to section 2.3.
Page 7
Revision 1.1