Output Ip Stream 1 & 2 Sections - evertz 7880IP-ASI-IP Manual

4.1.2. Output IP Stream 1 & 2 Sections
Please note that the controls for Output IP Stream 1 and 2 are identical, therefore for the sake of
simplicity only Output IP Stream 1 will be discussed in this manual.
•
Stream Active: This option allows the user to quickly enable or disable the outgoing Ethernet
stream by selecting either Active or Inactive.
•
Ethernet Output Port: This field shows which physical data port is being used for streaming
data.
•
Input: This field allows the user to select the source of the stream. The user will select either
ASI or IP.
•
Sources IP Address: This field enables the user to enter the source IP address. This address
can be the physical IP address of your data port, or any other address that you may want to be
encapsulated within the IP packets.
•
Sources UDP Port (0 to 65535): This field enables the user to enter the source port number
for the IP address entered above.
•
Destination IP Address: This field enables the user to enter the unicast or a multicast IP
address. Multicast addresses should be in the range of 224.0.0.0 through 239.255.255.255.
•
Destination UDP Port (0 to 65535): This field enables the user to enter the destination port
number for the IP address entered above.
•
RTP Protocol: Use this drop down box to enable (On) or disable (Off) the use of the RTP. The
use of RTP is recommended as it provides services such as time stamping, sequence
numbering and delivery monitoring, which can be beneficial for real-time delivery systems. Also
this protocol must be enabled if the user wishes to use the FEC (Forward Error Correction)
mode.
•
TOS: This field enables the user to enter the ToS (Type of Service) value, if your network does
not support ToS, use zero as default.
•
TTL: This field enables the user to enter the TTL (Time to Live) value. Using the multicast IP
protocol, the TTL value indicates the scope or range in which a packet may be forwarded. By
convention:
0 is restricted to the same host
1 is restricted to the same subnet
32 is restricted to the same site
64 is restricted to the same region
128 is restricted to the same continent
255 is unrestricted
7700/7800 MultiFrame Manual
7880IP-ASI-IP IP/ASI/IP Converter
Revision 1.1
Page 13