Assa Abloy SW200 Owner's Manual page 12

1 Guide Rails and Lock Stile – Check that the guide rails or other barriers or sepa-
rators are present (two per swing door side) and firmly anchored, (see Figures
4, 5, 6).
With the door open, grasp the lock stile of the door and attempt to move verti-
cally and horizontally. There should be no looseness in the door pivots or in the
connections between the door and operator.
2 Housekeeping – Check the door area for tripping or slipping hazards.
Check all door panels for broken or cracked glass. Panels should be made of
safety type material. There should be no bulletin boards, literature racks, mer-
chandise displays, or other attractions in the door area where people could be
hit by the door.
3 Traffic Patterns – Observe traffic patterns. Plan routing so people enter and exit
in a straight approach, directly on to the end of the mat.
4 Inspect the finger guard to ensure that it is secure and in good repair.
Note: Regardless of which activating device is used, if you have a problem you cannot correct, turn off the door operating
equipment and call your service representative.
12
Swing doors that are capable of both egress and
ingress shall be marked with a decal, visible from
Swing doors that are capable of both egress and
Swing doors that are capable of both egress and
both sides of the door, with the words CAUTION
ingress shall be marked with a decal, visible from
ingress shall be marked with a decal, visible from
Automatic Door, (see Figure 6). The words
both sides of the door, with the words CAUTION
both sides of the door, with the words CAUTION
Automatic Door must be at least ½ inch in size. It
Automatic Door, (see Figure 6). The words
Automatic Door, (see Figure 6). The words
should be mounted on the door at a height of 58
Automatic Door must be at least ½ inch in size. It
Automatic Door must be at least ½ inch in size. It
inches (14713 cm) from the floor to the
should be mounted on the door at a height of 58
should be mounted on the door at a height of 58
centerline of the sign. The sign shall be
inches (14713 cm) from the floor to the
inches (14713 cm) from the floor to the
minimum of 6 inches (15.2 cm) in diameter and
centerline of the sign. The sign shall be
centerline of the sign. The sign shall be
contain black lettering on a yellow background.
minimum of 6 inches (15.2 cm) in diameter and
minimum of 6 inches (15.2 cm) in diameter and
contain black lettering on a yellow background.
contain black lettering on a yellow background.
If you need additional decals for your automatic
doors, call your authorized Besam distributor.
If you need additional decals for your automatic
If you need additional decals for your automatic
doors, call your authorized Besam distributor.
doors, call your authorized Besam distributor.
3. Guide Rails and Lock Stile – Check that the
3. Guide Rails and Lock Stile – Check that the
guide rails or other barriers or separators are
3. Guide Rails and Lock Stile – Check that the
guide rails or other barriers or separators are
present (two per swing door side) and firmly
guide rails or other barriers or separators are
present (two per swing door side) and firmly
anchored, (see Figures 7, 8, 9).
present (two per swing door side) and firmly
anchored, (see Figures 7, 8, 9).
anchored, (see Figures 7, 8, 9).
With the door open, grasp the lock stile of the
With the door open, grasp the lock stile of the
door and attempt to move vertically and
With the door open, grasp the lock stile of the
door and attempt to move vertically and
horizontally. There should be no looseness in the
door and attempt to move vertically and
horizontally. There should be no looseness in the
door pivots or in the connections between the
horizontally. There should be no looseness in the
door pivots or in the connections between the
door and operator.
door pivots or in the connections between the
door and operator.
door and operator.
4. Housekeeping – Check the door area for tripping
4. Housekeeping – Check the door area for tripping
or slipping hazards.
4. Housekeeping – Check the door area for tripping
or slipping hazards.
or slipping hazards.
Check all door panels for broken or cracked
Check all door panels for broken or cracked
glass. Panels should be made of safety type Check all door panels for broken or cracked
glass. Panels should be made of safety type
material. There should be no bulletin boards, glass. Panels should be made of safety type
material. There should be no bulletin boards,
literature racks, merchandise displays, or other material. There should be no bulletin boards,
literature racks, merchandise displays, or other
literature racks, merchandise displays, or other
attractions in the door area where people could
attractions in the door area where people could
attractions in the door area where people could
be hit by the door.
be hit by the door.
be hit by the door.
5. Traffic Patterns – Observe traffic patterns. Plan
5. Traffic Patterns – Observe traffic patterns. Plan
5. Traffic Patterns – Observe traffic patterns. Plan
routing so people enter and exit in a straight
routing so people enter and exit in a straight
routing so people enter and exit in a straight
approach, directly on to the end of the mat.
approach, directly on to the end of the mat.
approach, directly on to the end of the mat.
6. Inspect the finger guard to ensure that it is secure
6. Inspect the finger guard to ensure that it is secure
6. Inspect the finger guard to ensure that it is secure
and in good repair.
and in good repair.
and in good repair.
NOTE!
NOTE!
NOTE!
Regardless of which activating device is used, if
Regardless of which activating device is used, if
Regardless of which activating device is used, if
you have a problem you cannot correct, turn off
you have a problem you cannot correct, turn off
you have a problem you cannot correct, turn off
the door operating equipment and call your
the door operating equipment and call your
the door operating equipment and call your
service representative. service representative.
service representative.



Page 8
Page 8
Page 8
Issue 2018-03-28
GENERAL SAFETY
5
5
5
Issued: 10-4-2011
Issued: 10-4-2011
Issued: 10-4-2011
Figure 4
Figure 5
Figure 6
Besam SW200i
Besam SW200i
Besam SW200i
1007717-en-US-3.0