Assa Abloy SW200 Owner's Manual page 10

Daily Safety Check – Swing Doors
Perform these safety checks daily on each automatic swinging door to ensure your customers' safety and your own protection.
If safety sensor is not working, door may swing at you without stopping.
Perform these safety checks daily on each automatic swinging door to ensure your customers' safety and
your own protection:
Motion Detector Actuation/Presence Detection Safety
Motion Detector Actuation/Presence Detection Safety
1. Check electronic sensor by walking toward the door
1 Check electronic sensor by walking toward the door opening. The door
opening. The door should start opening when you are
should start opening when you are about four feet from the door, and
about four feet from the door, and should swing open
should swing open smoothly and stop without impact. Walk slowly
smoothly and stop without impact. Walk slowly
through the door, (about 6 inches per second) the door should remain
through the door, (about 6 inches per second) the
open.
door should remain open.
2 Step out of the sensor zone. After a brief time delay (at least 1½ sec-
onds), the door should close to 10 degrees from fully closed, then no-
2. Step out of the sensor zone. After a brief time delay
ticeably slow down and take at least 1½ seconds for the final 10 degree
(at least 1½ seconds), the door should close to 10
closing.
degrees from fully closed, then noticeably slow down
3 Approach the safety side of the door first, then have someone else ap-
and take at least 1½ seconds for the final 10 degree
proach the activating side of the door. As long as you are in the safety
closing.
area of the door, it should not open, see Figure 1.
3. Approach the safety side of the door first, then have
someone else approach the activating side of the
door. As long as you are in the safety area of the
door, it should not open. (See Figure 1)
Caution: If safety sensor is not working, door may
swing at you without stopping.
Floor Mat Actuation/Floor Mat Safety
Floor Mat Actuation/Floor Mat Safety
1 Step on the opening mat.
2 It is necessary to have a safety mat covering the entire area the door
1. Step on the opening mat.
swings over. Step through the doorway onto the safety mat and remain
motionless for four seconds. The door should remain open. Repeat at
2. It is necessary to have a safety mat covering the
several locations on the mat, see Figure 2.
entire area the door swings over. Step through the
3 Step off the safety mat. After a brief time delay (at least 1 ½ seconds)
doorway onto the safety mat and remain motionless
the door should close to 10 degrees from fully closed, then slow down.
for four seconds. The door should remain open.
The last 10 degrees of closing should be noticeably slower (at least 1 ½
Repeat at several locations on the mat. (See Figure
seconds).
2.)
4 With the door closed, step on the safety mat. Have someone step on
the opening mat. Door should remain closed as long as someone re-
3. Step off the safety mat. After a brief time delay (at
mains on the safety mat.
least 1 ½ seconds) the door should close to 10
degrees from fully closed, then slow down. The last
10 degrees of closing should be noticeably slower (at
least 1 ½ seconds).
4. With the door closed, step on the safety mat. Have
someone step on the opening mat. Door should
remain closed as long as someone remains on the
safety mat.

Page 6
10
DAILY SAFETY CHECK
Issued: 10-4-2011
Issued: 10-4-2011
Issue 2018-03-28
Caution: If safety sensor is not
working, door may swing at you
without stopping.
Caution: If safety sensor is not
working, door may swing at you
without stopping.
Besam SW200i
Besam SW200i
1007717-en-US-3.0