Resetting The Memory; To Reset The Memory; Auto Power Off Function; Display Contrast - Casio KL-780 User Manual

Casio user's guide label printer kl-780
Hide thumbs Also See for KL-780:
Table of Contents

Advertisement

Resetting the Memory

You should reset the memory of the Label Printer before using it for the first
time, after you have not used it for a long time, or if nothing happens when you
turn power on, even after you change the batteries.
Important!
• Resetting Label Printer memory clears its memory of all input data.

To reset the memory

1. Make sure that Label Printer power is off.
2. While holding down the PRINT and ESC keys, press ON/OFF to turn power
on.
• This prompt confirms whether or not you want to initialize the Label Printer.
I N I T
3. Release the PRINT, ESC, and ON/OFF keys.
4. Press SET to initialize the Label Printer or ESC to abort the reset operation
without initializing anything.
• See "Initializing the Label Printer" on page E-21 for information on the initial
default settings of the Label Printer following the reset operation.

Auto Power Off Function

If you do not perform any key operation for about six minutes, the Label Printer
automatically turns power off. To restore power, press ON/OFF.

Display Contrast

Rotate the dial on the side of the Label Printer to adjust display contrast.
E-8
I
A
L
?
S
E
T
E S C

Tape Cartridges

Use the procedures described below to load a tape cartridge into the Label Printer.
Important!
• Never try to push the tape back into the cassette. Once tape is out of the
cassette, there is no way to wind it back in. Trying to do so can cause
operational problems with the Label Printer.
• The following are the tape widths that can be used with this printer: 6mm,
9mm, 12mm, 18mm.

To load a tape cartridge

1. Make sure that the Label Printer is turned off.
2. Lift open the cover.
3. Remove the stopper from a new tape cartridge
and check to see that the tape is ready to use.
• Make sure that the tape is under the tape guide and that it is not bent or
twisted.
Tape guide
OK!
• Make sure that the tape does not extend too far
past the tape guide. If it does, cut off the end with
a pair of scissors.
NO!

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KL-780 and is the answer not in the manual?

This manual is also suitable for:

Kl780l - ez-label printer

Table of Contents

Save PDF