Table of Contents
Advertisement
3.—Wrap the reducing nipple or the 1/4 inch male fitting with Teflon pipe tape, and then
install the pressure coupling. Use a 3/4 inch open-ended wrench to tighten the connection.
4.—Install the purge filter, pressure regulator and flowmeter, and then snap the assembly into
the pressure coupling.
5.—Connect the purge kit to your instrument, set the purge gas controls, and then snap the
flow coupler into the back of the instrument.
14
Using Your Nicolet iZ10 Module
Thermo Fisher Scientific
Advertisement
Table of Contents
