Table of Contents
Advertisement
Initializing the Label Printer
If you experience serious malfunction of the Label Printer or if operation fails
completely, try performing the following operation to initialize the printer.
Important!
• Initializing the Label Printer deletes all memory contents. Make sure you have
a back-up copy of text stored in memory if you need it.
To initialize the Label Printer
1. Turn power off.
2. While holding down the PRINT and SPACE keys, press ON/OFF to turn power
on.
• This prompt confirms whether or not you want to initialize the Label Printer.
I N I I T A
3. Release the PRINT, SPACE, and ON/OFF keys.
4. Press SET to initialize the Label Printer or ESC to abort the reset operation.
The tape width selection screen appears after initialization is complete.
5. Use z and x to select the width of the tape you will use and then press
SET.
E-24
L
I
Z
E
?
S
E
T
/
E
S C
Troubleshooting
• • • • • Power Supply
Nothing appears on the display.
Possible Causes
Battery power is low or
Load a fresh set of AA-size alkaline
the wrong type of
batteries (supplied by you).
batteries are loaded in
the printer.
Improper display contrast
Adjust display contrast.
setting
Batteries loaded
Remove batteries and reload them
incorrectly
correctly.
• • • • • Text Input
Cannot input text.
Possible Causes
FUNC key has been
Press ESC to clear FUNC key
pressed.
operation.
Action
Page
E-8
E-22
E-8
Action
Page
E-10
Hide quick links:
Advertisement
Table of Contents
