FujiFilm Sonosite PX Service Manual page 29

system. For maximum performance, ensure that the system is used in the environments described in these
tables.
Guidance and Manufacturer's Declaration - Electromagnetic Emissions per IEC 60601-1-2:2014
The Sonosite PX ultrasound system is intended for use in the electromagnetic environment
specified below.
Emissions Test
RF emissions
ClSPR 11
RF emissions
ClSPR 11
Harmonic emissions
IEC 61000-3-2
Voltage
fluctuations/flicker
emissions
IEC 61000-3-3
Guidance and Manufacturer's Declaration - Electromagnetic Immunity per IEC 60601-1-1-2:2014
The Sonosite PX ultrasound system is intended for use in the electromagnetic environment
specified below.
Immunity IEC 60601 Test
Test Level
Electrostatic ±8.0KV contact
Discharge
±2.0KV, ±4.0KV,
(ESD)
±8.0KV, ±15.0KV air
IEC 61000-4-2
Electrical fast ±2KV for power
supply lines
Transient burst
±1KV for
IEC 61000-4-4
input/output lines
Surge ±1KV line(s) to
line(s)
IEC 61000-4-5
±2KV line(s) to earth
Electromagnetic Environment
Compliance
Group 1 The Sonosite PX ultrasound system uses RF
energy only for its internal function. Therefore, its
RF emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
Class B The Sonosite PX ultrasound system is suitable for
use in all establishments other than domestic and
those directly connected to the public low-voltage
Class A
power supply network which supplies buildings
used for domestic purposes.
Complies
Compliance
Level
±8.0KV contact
±2.0KV, ±4.0KV,
±8.0KV, ±15.0KV
air
±2KV for power
supply lines
±1KV for
input/output lines
±1KV line(s) to
line(s)
±2KV line(s) to
earth
Electromagnetic
Environment
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30%.
Mains power quality should
be that of a typical
commercial or hospital
environment.
Mains power quality should
be that of a typical
commercial or hospital
environment.
Chapter 3: Safety 21