Maintenance - Tar River BPD-680 Operator's Manual

BPD-680/750 Post Hole Driver
Disassembly & Assembly of Driver Head/Breaker Chisel
Disassembly
1. Removing the auger from the auger system will make it
easier to balance and handle the attachment.
2. Using the skid loader, place the Driver-Breaker on its
back. The supports should be in place to securely balance
and support the attachment.
3. Carefully disconnect the skid loader from the Driver-
Breaker.
4. The skid loader transmission should be in neutral and
come to a complete stop before proceeding.
5. Turn off skid loader engine and remove key.
6. Remove the "A" stop pin to allow the driver/breaker chisel
to be released from the Post Driver.
Assembly
1. Clean and lubricate the driver head/breaker chisel.
2. Insert the driver head/breaker chisel into position.
3. Insert the stop pin, making sure it is fully inserted and in
the proper position.

Maintenance

15
"A" Stop Pin