Maintenance - Tar River SSP-250 Operator's Manual

Spreader Poly SSP-250, SSP-400
Danger: Never attempt to perform maintenance on the machine without first stop-
ping the towing vehicle's engine, setting the parking brake and removing the key
from the ignition. Always wear the proper protection (PPE) when performing ser-
vice. Refer to the chemical manufacturer for proper safety recommendations.
Proper maintenance is the responsibility of the owner/operator. Poor maintenance is an invitation to trouble.
•
Operate the spreader in an area with adequate ventilation. Never operate the engine of
•
the towing vehicle in a closed building. Exhaust fumes may cause asphyxiation
(suffocation) leading to serious injury or death.
•
Always use the proper tools or equipment for the job at hand. Maintenance area should be clean and dry.
•
Electrical outlets and tools are to be properly grounded.
Use extreme caution when making adjustments. Securely block equipment before servicing.
•
After servicing, be sure all tools, parts and service equipment are removed.
•
Use personal protection equipment (PPE) such as eye, hand, hearing and proper mask to filter any
•
chemicals used.
Check tightness of all hardware periodically, including; bolts, nuts, screws, pins. See page "Torque
•
Specification" Chart in page 21 for proper torque specifications.
Inspect tires for damage, wear and tear, and pressure. Add the proper amount of air according to the tire
•
manufacturers specifications. Pressure specifications can be found on the tire.
Use caution when inflating or servicing tires. Tires can be extremely dangerous if mishandled. Call on
•
trained professions to service the tires if necessary.
Where replacement parts are necessary for periodic maintenance and servicing, genuine factory
•
replacement parts must be used to restore your equipment to original specifications. The manufacturer will
not claim responsibility for use of unapproved parts and/or accessories and other damages as a result of
their use.
•
for injury or warranty.
Service
Before operating spreader:
Grease all exposed moving parts.
•
Check air pressure in tires.
•
Check all hardware for tightness.
•
Replace worn or damaged parts.
•

Maintenance

maintenance.
16
liability