Add The Sensor - HunterLab ColorFlex EZ Manual

iii. Option #3: Sentinel Key
a. If the user has a HunterLab USB hardware key, then it can be used with a new
iv. Option #4: 30-day trial
a. Fill out the registration form provided for the 30-day trial. Connect to the

Add the Sensor

1. Upon initial startup, the following message will be displayed: Sensor not yet installed.
Please install a sensor to take measurements. This message will remain until you
proceed to the SENSOR MENU > INSTALL > CONFIGURE command and install a new
sensor.
2. The Sensor Manager appears first:
3. Select ADD SENSOR to install a new sensor. The Setup Sensor screen allows selection of
the instrument model and the communications port. Select NEXT when ready.
10
ColorFlex EZ Supplemental Manual for EasyMatch QC v 1.2
sensor on the same computer. Return to Install, Step 5 (Figure 3) and select the
Sentinel Key to continue.
internet. HunterLab will approve the trial and email the SoftKey license back.
Follow the directions for Option #1 or #2 to complete.
Figure 7. Request 30-day Trial
Figure 8. Sensor Manager