Colorflex Ez Maintenance And Testing; Cleaning Of The Colorflex Ez; Diagnostic Test #1: Running Short Term Repeatability; Diagnostic Test #2: Running Long Term Repeatability - HunterLab ColorFlex EZ Manual

Hide thumbs Also See for ColorFlex EZ:

Table of Contents

The ColorFlex EZ requires minimal maintenance. This chapter describes cleaning of the instrument and

tiles and running diagnostic tests as part of normal instrument maintenance.

Clean the outside surfaces of the ColorFlex EZ using a soft cloth. Do not spray liquids directly on the

instrument.

Short Term Repeatability of your instrument may be tested using the calibrated white tile as follows:

1. Turn the ColorFlex EZ on and allow it to warm up for 2 hours. Meanwhile, clean the

calibrated white tile as described and allow the tile to return to room temperature.

2. Follow the instructions given in the SENSOR MENU > DIAGNOSTICS section to run the short

repeatability test that is built into EasyMatch QC.

Long Term Repeatability is measured using the Green Tile as follows:

1. If needed, clean the diagnostic green tile and allow the tile to return to room temperature.

2. Follow the instructions given in the SENSOR MENU > DIAGNOSTICS section to run the long-

term repeatability test that is built into EasyMatch QC.

Lamp replacement requires a trained technician. Contact HunterLab Technical Support to arrange for

lamp replacement. Please read "When You Need Assistance" prior to contacting HunterLab.

ColorFlex EZ Supplemental Manual for EasyMatch QC Ver 1.2

ColorFlex EZ Maintenance and Testing

Table of Contents

Do you have a question about the ColorFlex EZ and is the answer not in the manual?