Edit; Reading Samples And Standards - HunterLab ColorFlex EZ Manual

Edit

When you click EDIT, the Product Setup Configuration screen appears.
Use the scroll bar next to Setup Number or type a setup number into the box to choose a setup with
which to work. If you wish to begin working with the version of the setup that is already resident in
your instrument, click RETRIEVE. If you wish to work with the version of the setup that is shown on-
screen, do not click RETRIEVE.
Alter the setup parameters as desired. The parameters and selections available are the same as those
configured through your instrument firmware. If you are using a physical standard, you may click the
READ STANDARD button to read the standard to be saved with the setup using your instrument or
RECALL STANDARD to recall a standard from your EasyMatch QC database to be saved with the setup.
When all parameters are as desired for this setup, click UPDATE SENSOR to send the setup to your
instrument. You may retrieve all the setups from the instrument at once using the RETRIEVE ALL
button or send all the setups back to the instrument at once using the UPDATE ALL SETUPS button.
Complete the following steps to take individual readings using the ColorFlex EZ:
Note: These instructions apply when Average in the product setup is set to OFF.

Reading Samples and Standards

From the MEASUREMENTS MENU, you may read either a standard or a sample. You may also average
data. The functions available through the MEASUREMENTS MENU are described in the EasyMatch QC
Reference Manual.
It is recommended that the instrument be standardized at least once every four hours. Then you may
proceed with sample measurement.
ColorFlex EZ Supplemental Manual for EasyMatch QC Ver 1.2
Figure 13. Product Setup
15