Operation; Main Unit Operation - Sharp Plasmacluster FP-N40CX Operation Manual

OPERATION

MAIN UNIT OPERATION

FILTER
The unit will start operating when the MODE-ON / OFF Button is
pressed.
The unit will begin operating in the AUTO Mode. (fan level)
• While operating the Plasmacluster Indicator Light will be on.
To switch operating controls, press the MODE-ON / OFF Button until
the desired control is activated. (Your desired control will have its
Indicator Light lit.)
For the best results of the room environment, set your operation control as desired.
AUTO operation
The fan level is automatically
switched (HIGH, MEDIUM,
SILENT) depending on the
amount of impurities in the
air. The sensors detect the
impurities for efficient air pu-
rification.
SILENT operation
The unit will operate quietly
using minimal air intake.
For the first 30 seconds after the power plug is inserted into
the wall outlet, the unit will check the conditions of the air. If
operation is set to ON during this time, the CLEAN SIGN
LIGHT will alternately flash in green, orange and red.
MODE-ON/OFF Button
AUTO SILENT MED HIGH MAX POLLEN
Stop
OFF TIMER
CLEAN-SIGN
Plasmacluster Indicator Light
POLLEN mode operation
The unit will operate at High level
for 10 minutes, then will alternate be-
tween MEDIUM and HIGH.
10 minutes: High fan level
20 minutes: Medium fan level
20 minutes: High fan level
MEDIUM to MAX operation
The unit will operate at a fan level
of MEDIUM, HIGH or MAX.
E-12
Main Unit Controls
• AUTO
• SILENT
• MEDIUM
• HIGH
• MAX
• POLLEN
Plasmacluster