Filter Cleaning - Sharp Plasmacluster FP-N40CX Operation Manual

6
Dry the filter out-
doors if possible in
a well ventilated
area.
CAUTION
• Let the filter dry thoroughly.
If used while the filter is still moist, then the air
that is exhausted from the main unit will have
an odor. It may take 1 or 2 days to dry.
• Dry the filter outdoors in a well ventilated area.
If dried indoors, it may give an odor. In addi-
tion, the water dripping off the filter may soil
your floor.
• Make sure that the activated carbon has not
shifted to one side inside the filter. If it has, dis-
tribute it evenly with your fingers.
• Dry the filter as shown in the above illustration.
The wet filter is heavy. Fix it securely for drying
to make sure it does not fall down.
• The filter takes longer to dry in winter, on rainy
days. Wash it on a day when the weather is
good and dry it in the sun.
Move it indoors at night to prevent freezing.
7
Reinstalling the Filter and Restart
Reinstall the filter as shown on Page E-11.
• The filter air may have an odor until the filter is
completely dry.
8
Once the Washable Active Carbon
Filter has been cleaned, connect the
power cord to the outlet and use a
pointed instrument to activate the Fil-
ter Reset on the Remote Control,
pointing the Remote Control toward
the receiver on the main unit,
(Refer to page E-13)
• Once the Filter Reset Button has been acti-
vated, you will hear a beep sound that means
that the unit has been reset.
• The Filter indicator light will then go out auto-
matically.
Filter Reset Button
E-15

FILTER CLEANING

Clean the top surface of the Pre-Filter
lightly with a vacuum cleaner.
Pre-Filter
NOTE
• The True HEPA Filter is damaged eas-
ily. Do not bring it into direct contact
with the nozzle of a vacuum cleaner or
wash it with water. The True HEPA Fil-
ter should never be washed or cleaned.