Preparation; Filter Installation; Inserting Batteries In The Remote Control - Sharp Plasmacluster FP-N40CX Operation Manual

PREPARATION

FILTER INSTALLATION

To maintain the quality of the filters, they are placed in the main unit within plastic bags.
Be sure to remove the filters from the plastic bags before using the unit.
1
Filters Removal
1
Place the unit facing up
Lay the unit on a flat surface such as a table,
making sure that the stand does not contact the
surface.
2
Remove the Front Panel
Press in the hook on the bottom
of the Front Panel and lift to re-
move.
3
Remove the Pre-Filter, and then re-
move the Washable Active Carbon Fil-
ter (black) and True HEPA Filter (white)
from the plastic bags.
The Washable Active Carbon Filter is reinforced
with cardboard to prevent it losing its shape.

INSERTING BATTERIES IN THE REMOTE CONTROL

Be sure to remove the power plug from the wall outlet.
1
Remove the
back cover
Press and slide the
back cover to re-
move.
2
Insert batteries
Insert batteries with
and as shown
below.
3
Close the back
cover
E-10
Soft cloth
2
1
Hook
Washable Active Carbon Filter
Battery Information
• The batteries for this remote control are for ini-
tial use only . Change the batteries when nec-
essary.
• Incorrect usage of the batteries may cause bat-
tery fluid leakage and/or damage.
Take care of the following when handling:
• When replacing the batteries, replace both bat-
teries with new ones of the same type. (Use 2
AA manganese batteries.)
• When not using the unit or remote control for
an extended period, remove the batteries. (This
prevents malfunction of the remote control from
battery fluid leakage.)
• The batteries of the accessory are for initial use
only and may be depleted within 1 year.
Place so that
stand does not
touch surface.
Table, etc.
Front Panel
2
1
Pre-Filter
1