Monitored Parameters; Controlled Parameters; Table 6-1: Vistalink Monitored Parameters; Table 6-2: Vistalink Controlled Parameters - evertz 7707CVR-8 Series Manual

6.2. VISTALINK

MONITORED PARAMETERS

®
The following parameters can be remotely monitored through the VistaLINK
Parameter
Video 1 to 8 Standard
Video 1 to 8 Signal Valid
Optical Power and
Threshold
Optical Link
Optical Link Error
Card Type
6.3. VISTALINK

CONTROLLED PARAMETERS

®
When the MASTER jumper is set to the REMOTE position, the following parameters can be remotely
controlled through the VistaLINK
local jumper settings will override the settings configured through the VistaLINK
Parameter
Video 1 to 8 DC Offset
Video 1 to 8 Gain
Video 1 to 8 EQ
Video 1 to 8 Blocking
New Password
Optical Power Alarm
Threshold
Description
A range of values describing the detected video signal
Indicates the valid video signal
A range of values describing optical power at the fiber input and if this value
is below user set threshold
Indicates the presence of a valid optical link with a 7707CVT-8 module
Indicates the presence of optical link errors if errors exists
Indicates either 7707CVR-8, 7707CVR-8-H card type.
Table 6–1: VistaLINK
interface. When the MASTER jumper is set to the LOCAL position the
®
Description
A range of values describing DC Offset at the Video output (1 to 8)
A range of values describing Gain of Video 1 to 8 output as a
percentage (100 % = unity gain)
A range of values describing the pre-emphasis being applied to the
Video 1 to 8 output
Allows user to block channels 1 to 8
Allows user to change current password
Controls the power alarm threshold. VLPro Control Parameter Only.
Table 6–2: VistaLINK
®
Revision 1.0
7700 MultiFrame Manual
7707CVR-8 Eight Analog Video Fiber Receiver
Monitored Parameters
®
Controlled Parameters
interface.
®
interface.
®
7707CVR-8 - 15