Analog Devices ADSP-CM419F EZ-KIT Manual page 18

1. Connect the EZ-KIT board to a personal computer (PC) running IAR Embedded WorkBench, using a J-
Link/J-Trace emulator:
a. Plug one side of the USB cable into the USB connector of the emulator. Plug the other side into a USB
port of the PC running IAR Embedded WorkBench.
b. Attach the emulator to the header connector,
2. Attach the provided cord and appropriate plug to the 5V power adapter:
a. Plug the jack-end of the power adapter into the power connector
b. Plug the other side of the power adapter into a power outlet. The power LED (
power is applied to the board.
It is assumed that the IAR Embedded WorkBench software is installed and running on your PC.
1. Navigate to the IAR Embedded WorkBench environment via the Start menu.
2. Choose File > Open > Workspace to open a workspace for the project to download and debug.
3. Choose Project > Options.
The General Options, Target page appears.
4. In Processor variant, ensure Device is Analog Devices CM41x
5. Choose Debugger in the Category pane.
The Debugger, Setup options page appears.
a. In Driver, choose J-Link/J-Trace as the emulator to be used to debug the target board.
b. Click the Download tab. The Debugger, Download options page appears.
c. Ensure Use flash loader(s) is enabled. Note that other download settings are optional.
6. Choose Debugger > J-Link/J-Trace in the Category pane.
The emulator Setup options page appears.
a. On the Setup page,
• In Reset, select Connect during reset from the drop-down list.
• In JTAG/SWD speed, select Auto.
• (Optional) In Clock setup, change the default values.
b. On the Connection page,
• In Communication, select USB and Device 0.
• In Interface, select SWD.
7. Click OK to save the emulator settings.
®
ADSP-CM419F EZ-KIT Manual
P1 P2
or , on the EZ-KIT board.
P19
IAR Embedded WorkBench Setup
on the EZ-KIT board.
LED1
) is lit green when
2–5