Computer Input; Selecting Input Source - Sanyo PLC-XT10 Owner's Manual

COMPUTER INPUT

DIRECT OPERATION
Select INPUT source by pressing INPUT button on Top Control.
Select INPUT source by pressing COMPUTER 1 or COMPUTER 2
button on Remote Control Unit.
If projector cannot reproduce proper image, select correct input source
through MENU OPERATION (see below).
MENU OPERATION
When connect the output (Analog) from computer to
Computer 1 (HDB 15-pin) terminal on the projector.
Press MENU button and ON-SCREEN MENU will appear. Press
1
POINT LEFT/RIGHT button to move a red frame pointer to
INPUT Menu icon.
2 Press POINT DOWN button to move a red arrow pointer to
Computer 1 and then press SELECT button. Source Select
Menu will appear.
3 Press POINT DOWN button and a red-arrow icon will appear.
Move arrow to "RGB" and press SELECT button.
When computer is connected to Computer 1, select
RGB
RGB.
When video equipment is connected to Computer 1
RGB (Scart)
terminal, select RGB (Scart). Refer to P31.
When connect the output (Digital/Analog) from computer
to Computer 2 (DVI-I) terminal on the projector.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT button to move a red frame pointer to
INPUT Menu icon.
Press POINT DOWN button to move a red arrow pointer to
2
Computer 2 and then press SELECT button. Source Select
Menu will appear.
Move a pointer to either RGB (Digital) or RGB (Analog) and then
3
press SELECT button.
When digital signal is connected to DVI terminal,
RGB (Digital)
select Digital.
When analog signal is connected to DVI terminal,
RGB (Analog)
select Analog.
22

SELECTING INPUT SOURCE

INPUT button
Computer 1
Computer 2
Video
INPUT MENU
INPUT Menu icon
Move a pointer (red arrow)
to Computer 1 and press
SELECT button.
Computer 1
Source Select Menu
Move a pointer to RGB
and press SELECT button.
INPUT MENU
INPUT Menu icon
Move a pointer (red arrow)
to Computer 2 and press
SELECT button.
Computer 2
Source Select Menu
Move a pointer to RGB
(Digital) or RGB (Analog)
and press SELECT button.