Computer Input; Input Source Selection - Sanyo PLC-SE20 Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Choose either Computer 1 or Computer 2 by pressing the INPUT
button on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be selected
through menu operation as described below.
Menu Operation
1 Press the MENU button and the On-Screen Menu will appear.
Press the Point Left/Right button to move the red frame pointer
to the Input Menu icon.
2
Press the Point Down button to move the red arrow pointer to
either Computer 1 or Computer 2 (Only the Computer 1 is
displayed when Monitor out is selected in the Setting Menu.),
and then press the SELECT button. The Source Select Menu
will appear.
3
Move the pointer to the correct input source and then press the
SELECT button.
When the input source is analog coming from a
RGB (Analog)
computer through the DVI terminal, select RGB
(Analog).
When the input source is digital coming from a
RGB (PC Digital)
computer through the DVI terminal, select RGB (PC
Digital)
When the input source compatible with HDCP is
RGB (AV HDCP)
coming from video equipment through the DVI
terminal, select RGB (AV HDCP).
When the input source is analog coming from a
RGB
computer
2/COMPONENT IN/MONITOR OUT terminal, select
RGB.
NOTE
G
HDCP (High-bandwidth Digital Content Protection) is a system for
protecting digital entertainment content delivered by DVI (Digital Visual
Interface) from being copied.
The specification of HDCP is decided and controlled by Digital Content
Protection, LLC. Should the specification be changed, this projector may
not display the digital content protected by HDCP.
24
through the COMPUTER
INPUT button
Computer 1
✽
Computer 2
Video
COMPUTER button
Computer 1
✽
Computer 2
✽
Computer 2 is not displayed when the COMPUTER IN
2/COMPONENT IN/MONITOR OUT terminal is used as
Monitor out.
Input Menu
Input Menu icon
Move the pointer (red arrow)
to Computer 1 and press the
Computer
SELECT button.
1
Source Select Menu
Move the pointer to
RGB(Analog), RGB (PC
Digital), or RGB(AV HDCP)
and press the SELECT but-
ton.
✽
Computer 2 is not displayed when the COMPUTER IN
2/COMPONENT IN/MONITOR OUT terminal is used as
Monitor out.
Input Menu
Input Menu icon
IN
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Computer
2
Source Select Menu
Move the pointer to RGB and
press the SELECT button.