Adjustable Feet; Moving Projector - Sanyo PLC-XT10 Owner's Manual

PREPARATION
Picture tilt and projection angle can be adjusted by rotating
ADJUSTABLE FEET. Projection angle can be adjusted to 10
degrees.
Lift the front of a projector and pull FEET LOCK LATCHES
1
on the both sides of a projector.
Release FEET LOCK LATCHES to lock ADJUSTABLE FEET
2
and rotate ADJUSTABLE FEET to fine tune position and tilt.
To retract ADJUSTABLE FEET, lift the front of a projector
3
and pull and undo FEET LOCK LATCHES.
Keystone distortion of a projected image can be adjusted by
Menu Operation. (Refer to P20 and 36.)
NOTE :
THIS PROJECTOR
INDICATED. PROJECTION LAMP MAY MALFUNCTION.
Use Carry Handle when moving a projector.
When moving a projector, replace Lens Cover and retract
Adjustable Feet to prevent damage to the lens and cabinet.
When a projector is not in use for an extended period, put it into
the case (dust cover) supplied with a projector.
CAUTION
Dust Cover (supplied) is intended for protection from dust and
scratches on the surface of a cabinet, and it is not designed to
protect an appliance from external forces. Do not transport a
projector through a courier or transport services with this cover.
The projector can be damaged. When handling a projector, do not
drop, bump, subject it to strong forces or put other things on the
cabinet.
CAUTION IN CARRYING OR TRANSPORTING THE PROJECTOR
Do not drop or bump a projector, otherwise damages or malfunctions may result.
When carrying a projector, use a suitable carrying case.
Do not transport a projector by using a courier or transport service in an unsuitable transport case. This may cause
damage to a projector. To transport a projector through a courier or transport service, consult your dealer for best
way.
10

ADJUSTABLE FEET

SHOULD BE SET IN THE WAY

MOVING PROJECTOR

ADJUSTABLE FEET
FEET LOCK
LATCHES