Video Input; Selecting Input Source - Sanyo PLC-XT10 Owner's Manual

VIDEO INPUT

DIRECT OPERATION
Select INPUT source by pressing INPUT button on Top Control.
Select INPUT source by pressing COMPUTER 1 or VIDEO button on
Remote Control Unit.
If projector cannot reproduce proper image, select correct input source
through MENU OPERATION (see below).
MENU OPERATION
When connecting to those equipment, select a type of
Video source in SOURCE SELECT MENU.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT button to move a red frame pointer to
INPUT Menu icon.
2 Press POINT DOWN button to move a red arrow pointer to
Video and then press SELECT button. Source Select Menu will
appear.
Move a pointer to the source that you want to select and then
3
press SELECT button.
Projector automatically detects incoming Video signal,
Auto
and adjusts itself to optimize its performance.
• When both VIDEO jack and S-VIDEO jack are
connected, S-VIDEO jack has priority over VIDEO jack.
• When both Y-Pb/Cb-Pr/Cr jacks and S-VIDEO jack are
connected, Y-Pb/Cb-Pr/Cr jacks have priority over S-
VIDEO jack.
When video input signal is connected to VIDEO jack,
Video
select Video.
When video input signal is connected to S-VIDEO jack,
S-Video
select S-Video.
When video input signal is connected to Y-Pb/Cb-
Y,Pb/Cb,Pr/Cr
Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
When connect the 21-pin Scart (RGB) output from video
equipment to computer 1 (HDB 15-pin) terminal on the
projector.
Press MENU button and ON-SCREEN MENU will appear. Press
1
POINT LEFT/RIGHT button to move a red frame pointer to
INPUT Menu icon.
Press POINT DOWN button to move a red arrow pointer to
2
Computer 1 and then press SELECT button. Source Select
Menu will appear.
3 Press POINT DOWN button and a red-arrow icon will appear.
Move arrow to "RGB (Scart)" and press SELECT button.

SELECTING INPUT SOURCE

INPUT button
Computer 1
Computer 2
Video
INPUT MENU
Move a pointer to Video and
press SELECT button.
VIDEO
Source Select Menu (VIDEO)
Move a pointer to the source
and press SELECT button.
INPUT MENU
INPUT Menu icon
Move a pointer (red arrow)
to Computer and press
SELECT button.
Computer 1
Source Select Menu
Move a pointer to
RGB (Scart) and press
SELECT button.
31