Sanyo PLC-XF20 Owner's Manual page 49

DVI-I TERMINAL (DIGITAL/ANALOG)
This terminal accepts only Digital (TMDS) or Analog (RGB) output signal. Connect the display output terminal of the
computer to this terminal with the DVI cable (supplied).
Pin Configuration
C1 C2
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
C3 C4
C5
HDB 15-PIN TERMINAL (ANALOG)
Connect the display output terminal of the computer to this terminal with the VGA Cable (supplied).
When connecting the Macintosh computer, use MAC/VGA Adapter (supplied).
When connecting the Analog signal from DVI terminal of the computer to this terminal, use DVI/VGA Adapter (supplied).
Pin Configuration
4 3 2 1
5
10 9 8 7 6
15 14 13 12 11
CONTROL PORT CONNECTOR
Terminal : Mini DIN 8-PIN
Connect control port (PS/2, Serial or ADB port) on your computer to this terminal with the Control Cable (supplied).
Pin Configuration
8 7 6
5 4 3
2 1
CONFIGURATIONS OF THE TERMINALS
C1 Analog Red Input
C2 Analog Green Input
C3 Analog Blue Input
C4 Analog Horiz. sync
C5 Analog Ground (R/G/B)
1 T.M.D.S. Data2–
2 T.M.D.S. Data2+
3 T.M.D.S. Data2 Shield
4 No Connect
5 No Connect
6 DDC Clock
7 DDC Data
8 Analog Vert. sync
1 Red Input
2 Green Input
3 Blue Input
4 Sense 2
5 Ground (Horiz.sync.)
6 Ground (Red)
7 Ground (Green)
8 Ground (Blue)
PS/2 Serial ADB
1 ----- R X D -----
2 CLK ----- ADB
3 DATA ----- -----
4 GND GND GND
5 ----- RTS -----
6 ----- T X D -----
7 GND GND -----
8 ----- GND GND
9 T.M.D.S. Data1– 17
10 T.M.D.S. Data1+ 18
11 T.M.D.S. Data1 Shield 19
12 No Connect 20
13 No Connect 21
14 +5V Power 22
15 Ground (for +5V) 23
16 Hot Plug Detect 24
9 No Connect
10 Ground (Vert.sync.)
11 Sense 0
12 Sense 1
13 Horiz. sync.
14 Vert. sync.
15 Reserved
APPENDIX
T.M.D.S. Data0–
T.M.D.S. Data0+
T.M.D.S. Data0 Shield
No Connect
No Connect
T.M.D.S. Clock Shield
T.M.D.S. Clock+
T.M.D.S. Clock–
49