Sanyo PLC-XF20 Owner's Manual page 13

SERIAL PORT
IN TERMINAL
If you control the projector by computer,
you must connect a cable (not provided)
from your computer to this terminal.
SERIAL PORT
OUT TERMINAL
This terminal outputs the
signal from SERIAL PORT
IN. More than two projectors
can be controlled with one
computer by connecting
SERIAL PORT IN. of another
projector to this terminal.
R/C JACK
When using the Wired / Wireless
Remote Control Unit as the Wired
Remote Control, Connect the Wired
Remote Control Unit to this jack with
the Remote Control Cable (supplied).
(Refer to page 19.)
SERIAL PORT IN
SERIAL PORT OUT
R/Pr
R/C JACK
USB
VIDEO/Y
AUDIO OUT
R L
RESET
(MONO)
AUDIO OUTPUT JACKS
Connect an external audio
amplifier to these jacks.
(Refer to P14, 15.)
CONNECTING THE PROJECTOR
USB PORT
This port is used to control the
projector with the computer. It is also
used to control the computer with the
Remote Control of this projector.
(Refer to P40, 42.)
Connect the USB port of the
computer to this port.
AUDIO
DVI
R
AUDIO
G/Y B/Pb H/HV V
R
AUDIO
S-VIDEO
C
R
AUDIO
ANALOG RGB
R
RESET BUTTON
This projector uses a micro processor to control the
unit. Occasionally, the micro processor may
malfunction and need to be reset. This can be done
by pressing the RESET button with a pen, which will
shut down and restart the unit. Do not use the
RESET function excessively.
CONTROL PORT
L
(MONO)
CONTROL PORT
L
(MONO)
L
(MONO)
CONTROL PORT
L
(MONO)
13