Pip Button; Keystone Button - Sanyo PLC WTC500AL Owner's Manual

PIP button

Press the PIP button on the remote control to select Picture
in Picture or Picture by Picture mode. See page 52 for
details.
PIP VOL . button
Press the PIP VOL. button on the remote control at the PIP
mode. The volume dialog box appears. Use the Point 7 8
buttons to adjust the volume.
SHUTTER button
See pages 28 and 58 for details.
P-TIMER button
Press the P-TIMER button on the remote control. The P-Timer
display "00:00" appears on the screen and the countdown
starts (00:00–59:59).
To stop the countdown, press the P-TIMER button. To cancel
the P-Timer function, press the P-TIMER button again.

KEySTONE button

Press the KEYSTONE button on the remote control. The
"Keystone" appears on the screen.
Use the Point ed7 8 buttons to correct keystone
distortion. The keystone adjustment can be stored
(p.45).
Reduce the upper width
with the Point button.
e
Reduce the lower width
with the Point button.
d
Remote Control
P-TIMER
button
PIP button
PIP VOL .
button
✔
Note:
• See the previous page for the
description of other buttons.
P-Timer display
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control again while the Keystone dialog box is being
displayed, the keystone adjustment will be canceled.
•The adjustable range can be limited depending on the
input signal.
• "Keystone" disappears after 10 seconds.
Reduce the left part with
Point button.
7
Basic Operation
KEySTONE
button
SHUTTER
button
Reduce the right part with
Point button.
8
31