Input Source Selection - Sanyo PLC WTC500AL Owner's Manual

Input Source Selection

Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
frame pointer to the Input Menu icon.
2
Use the Point buttons to move the red arrow
ed
pointer to the desired input and then press the
SELECT button. The signal format menu appears.
3
Use the Point buttons to select the desired signal
ed
format and then press the SELECT button.
INPUT 1
When the RGB PC (analog) signal is
RGB (PC analog)
connected
When the RGB PC (scart) signal is
RGB (Scart)
connected
When the HDMI signal is connected.
HDMI
INPUT 2
When the RGB PC signal is connected.
RGB
When the video signal is connected.
Video
When the component signal is
Component*
connected.
* If the projector cannot reproduce proper video image, select a
system manually (see "Video System Selection" on page 36)
*"Component" can accept the component signal and the analog
RGB signal. Some unsupported RGB signals may be detected to
component signals. In this case, please set to "RGB"manually.
INPUT 3
When the video signal is connected.
Video*
When the S-video signal is connected.
S-video*
* If the projector cannot reproduce proper video image, select a
system manually (see "Video System Selection" on page 36).
7 8 buttons to move the red
Input Menu
Input Selection
35