Sanyo PLC WTC500AL Owner's Manual page 58

Setting
Shutter
Shutter function is available to block out light to the
screen, so that the screen can be used for the other
presenters.
Protection
Prohibits the shutter operation from the remote control
and the projector's top control.
Remote control ... Selecting "On" prohibits the shutter
Projector . . . . . ... Selecting "On" prohibits the shutter
It is possible to prohibit the shutter operation from both of
the remote control and the top control.
Management
The Shutter Management function turns off the projection
lamp when the projector is left with the shutter closed and
the set time has passed away. The count-down time can be
set between 5 and 180 minutes. When the count-down time
has elapsed, the shutter will be opened up automatically and
the lamp will be turned off to cool itself down. The SHUTTER
indicator is blinking blue during this cooling-off period. When
the lamp has been fully cooled down, the READY indicator
turns green lighting and the SHUTTER indicator keeps
blinking. Should the ON / STAND-BY button be pressed in
this condition, the projection lamp will be turned on and the
SHUTTER indicator turns off.
HDMI setup
Set Image and Sound according to the output signal of video
equipment. Press the Point 7 8 buttons to switch between each
option.
Image . . . Normal :
Enhanced : When the output of video equipment is
Sound . . . HDMI :
AUDIO1:
The names for the output setting of video equipment vary from
equipment to equipment. For details, refer to the owner's manual
of video equipment.
When the black part of the image are destroyed or stand out,
please switch to "Normal" or "Enhanced"
signal of video equipment.
58
operation from the remote control.
operation from the top control.
When the output of video equipment is
set to "Normal. "
set to "ENHANCED. "
Select when use PCM AUDIO (DIGITAL
AUDIO)
Select when use AUDIO1 input
according to the output
✔ Note:
•The Factory default value is set to 180 minutes
for the count down time.
•The Shutter Management function cannot be
halted.
HDMI setup
Press the Point 7 8 buttons
to select Normal or Enhanced
according to the output signal
of video equipment and HDMI
or Audio1 according to the input
sound.
✔
Note:
• HDMI setup is not grayout and inoperative
other than HDMI input selection mode.