Power Management; Filter Counter - Eiki EK-130U Owner's Manual

Power management

For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period. Select
one of the following options:
Ready
When the lamp has been fully cooled down, the
POWER indicator changes to green blinking. In
this condition, the projection lamp will be turned
on if the input signal is reconnected or any button
on the remote control or top control is pressed.
Power off
When the lamp has been fully cooled down, the
power will be turned off.
Off
Power management function is off.
Timer
If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer
display with No signal appears. It starts the countdown until the lamp is turned off. Press 
button to set the Timer(1~30min.)
Ready countdown
Set the time that ready status transfers to standby status automatically.(0-30min. 0 Min: not
transfer automatically)
In ready status, press POWER button to switch to standby status, and press any other button to
turn on the projector.

Filter counter

This function is used to set a frequency for filter cleaning.
When the projector reached a specified time between
cleanings, a Filter warning icon appears on the screen,
notifying the cleaning is necessary. After cleaning the
filter, be sure to select RESET and set the timer. The
Filter warning icon will not turn off until the filter counter
is reset.
Filter counter
Display the using time of the filter.
Timer
Set the time to displaythe warning icon.
Select Timer from OFF/100/200/300.
Filter counter reset
Reset the filter counter.(See page 72)
Filter check
Check the temperature iside the projector and make reactions.
On: enable the filter check function
*when the projector checked any filter issue the warning message would pop-up automatically
Off: disable the filter check function
Note:
● The warning message will automatically disappear after 30 seconds, there only the power
button is effective during that period.
● The warning message will pop-up again if the projector has checked the filter warning condition.
54
Expand
Power management
Filter counter
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter reset
No signal
01 : 20
Time left before Lamp is off.
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter reset