Table of Contents
Advertisement
Service Manual
ALX 720
The two lower axles slip into the holes of the inner side plate and have to be adjusted in a way
that 1,8 mm (+/- 0,1 mm) of the axles are looking out of the inner side plate
Fix the axles by use of the hexagonal screws.
1,8 mm
The upper – rear axle fits into the hole of the metal part
Guide the cable of the full size sensor into the printer (trough the metal casting).
Press the inner side plate against the metal casting – the two axles fit into the holes in the metal
casting.
Press the outer side plate against the steel plate and fix it with the hexagonal screws in a way
that the whole assembly is fixed secure.
Release 11/2003
Page 45
Adjustment
Advertisement
Table of Contents
