Service Manual
ALX 720
10 Fullsize label sensor
10.1 Assemble Option
10.1.1 Change position of pressure lever
The lever position has to be changed from its normal position to a position rotated 90 degrees
(see photo).
pressure
lever
axle
lock washer
Open the lock washer, push back the axle – remove the lever from the axle – rotated the lever
(90 degree) and pull the lever back to the axle.
Move the axle back into the hole of the metal plate and lock it with the washer.
10.1.2 Mount full size sensor
Move the outer side plate from the inner side to the steel plate (see picture) and insert the old
axles into the drilled holes to lock the plate in this position. Take care that the axles are inserted
just 1 cm.
Release 11/2003
Page 42
Adjustment