Table of Contents
Advertisement
Service Manual
ALX 720
14. Loose screw on pressure lever.
15. Loose disk.
Don't fasten too strong on assembly!
16. Turn rocker in print position (lowest Po-
sition).
17. Put 0.1 mm thick material between
rocker and pressure lever.
18. Press
pressure lever (1) against the
rocker and fasten the screw. Remove
material
19. Switch on machine. The printer should
be still in the HADJ Modus (Hx).
20. The gap in the disk (2) should be on the
highest position (12 h).
Turn the gap in the disk slowly clockwise
(seen from the backside), until the dis-
play show 0 (Zero). This should happen
on the first edge of the gap (3).
Fasten disk carefully. If this is done too
strong you destroy the plastic coil.
21. Press ENTER-key. The printer performs
a reset !
After this adjustment the head position should
be ok.
Release 11/2003
Print position
2
Page 28
Material
1
3
LS
Adjustment
Advertisement
Table of Contents
