Table of Contents
Advertisement
Page 6
Storage of the doseBadge
The doseBadge should be stored in a fully charged state. If the doseBadge is
not used for 1 hour, it will shutdown and go into sleep mode.
To wake the doseBadge from the Sleep mode, shake the doseBadge until the
indicator light shows. Refer to "Shake-to-Wake" function on Page 18 for detailed
information about this function.
The "Shake to Wake" function has been added to the doseBadge to ensure that a
doseBadge that is not in use powers down to the minimum possible power
consumption.
The doseBadge should be kept on the charger unit when not in use to ensure optimum
performance. The doseBadge should be charged at least every 14 days to maintain this
optimum performance.
Battery Operating Life
The doseBadge system should be returned to Cirrus Research plc for
calibration and servicing. During this calibration and service, the performance
of the internal battery will be verified.
Installing the doseBadge Software
The doseBadge system is supplied with the dBLink3 software package.
dBLink3 is a program that allows measurements to be downloaded from the RC:112A
Reader unit to a PC. The dBLink3 software automatically recognises an RC:112A Reader
unit and allows measurements to be downloaded.
dBLink3 and the doseBadge Database are supplied on a CD-ROM and require a
PC running Microsoft 98SE or later. Install the software before connecting the
doseBadge Reader Unit to the PC.
To install the software:
1. Insert the Disc in the CD-ROM drive
2. Follow the instructions on the screen
If the installation program does not automatically start, run d:\setup.exe program from
the Start, Run option in the task bar where d is the letter of the CD-ROM drive.
Please note that if you are running on a network, you may need to contact
your network administrator to ensure that you have sufficient access rights to
install this software. This software should be installed with full administration
rights to ensure that the configuration of the software can be completed.
Cirrus Research plc accepts no responsibility for the installation of this software on
systems where full access rights are not available.
CR:112A & CR:112AIS doseBadge User Manual
Advertisement
Table of Contents
