Table of Contents
Advertisement
Page 40
Changing the Reader Batteries
The doseBadge Reader unit shows the battery level in the top right hand corner of the
display as shown below. The figure on the left below shows a full battery level and the
figure on the right shows the battery level at 10% of the full capacity.
The memory of the Reader unit is protected when the batteries are removed. The clock
of the Reader will be reset after 15 minutes when the batteries are removed.
Locate the battery compartment cover and remove it from the instrument.
Remove the batteries from the Reader unit and replace with batteries of equivalent type
and quality.
The battery should be of alkaline type AA (LR6 / AM3 / MN1500 / Mignon).
Ensure that the polarity of the batteries is correct. Replace the battery cover and switch
the Reader unit on.
doseBadge User Manual
The batteries for the RC:112A
Reader unit are located under
the black cover on the back of
the instrument. Before
changing the main batteries,
ensure that the Reader is
switched off.
Advertisement
Table of Contents
