Table of Contents
Advertisement
Section 4 Configuration & Options
RC:112A Reader Keypad
The keypad of the RC:112A Reader unit has the following keys as shown in the figure
above:
(1) Reset
Resets the doseBadge. All information in the doseBadge is deleted
and the configuration data programmed.
(2) Cal
Calibrates the doseBadge using the internal Acoustic Calibrator. This
key is also used for the second calibration check if required.
(3) OK
Accepts data entry or confirms menu options.
(4) Arrow Keys
Allows the user to move around the menus and information shown
on the display.
(5) Menu
Displays the menu options.
(6) Read
Downloads the measurement information from the doseBadge to the
Reader.
(7) Stop
Stops the doseBadge measurement
(8) Run
Starts the doseBadge measurement
(9) Cancel
Exits from the menu options.
(10) Power
Switches the Reader on and off. The Reader will automatically
switch off after 2 minutes of inactivity.
CR:112A & CR:112AIS doseBadge User Manual
Page 29
Advertisement
Table of Contents
