Completing The Configuration - IBM WebSphere DataPower XC10 Installation Manual

Note: The verification procedure assumes that the hostname for the Ethernet
To access the user interface from a browser, use the following procedure:
1. Open a Web browser. From a network-connected PC, open your Web browser.
2. Enter the URL. In the address bar, enter the URL defined during the device
3. Log in to the appliance. Log in to the appliance with the local xcadmin account
4. Click Login.

Completing the configuration

Configuration beyond the base configuration is beyond the scope of this document,
though the following steps provide a general outline of the process for defining
your DataPower XC10 appliance:
1. Configure Domain Name System (DNS) servers. You can use the DataPower
2. Use network time servers. Using an Network Time Protocol (NTP) server for
3. Set up mail delivery and notifications. E-mail notifications use the SMTP server
4. Configure logging and auditing. For more information, see the audit reporting
5. Download or update firmware. To download or update the DataPower XC10
Use the documentation available in the information center at the following Web
address to complete the configuration: http://publib.boulder.ibm.com/infocenter/
wdpxc/v1r0/index.jsp
22
IBM WebSphere DataPower XC10: Installation Guide
interface is myXC10.ibm.com.
initialization. For example:
https://myXC10.ibm.com
.
Note: You must use the https protocol, not http.
and password.
If the Welcome page displays, authentication of the local xcadmin account is
successful.
XC10 user interface to configure settings to specify the DNS server to be used
by the appliance. For more information about setting up domain name servers,
see the information about managing DNS servers in the information center.
clock synchronization for the appliance is highly recommended.
you can define. Although not required, you should configure an SMTP server
because password reset is done using e-mail. If a user forgets the password and
an SMTP server is not configured, then that user is not able to receive a new
password. See the information about managing e-mail delivery in the
DataPower XC10 information center for details.
information in the information center.
firmware, you must have appliance administration permissions and you can
use the following general procedure:
a. Browse to the IBM support site to download the firmware image.
b. Upload the firmware image to the appliance.
The appliance is not required to have connectivity to the external internet. For
more information about downloading or updating firmware, see updating the
firmware information in the information center.