Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Original Tractor Cabs Manuals
  4. Tractor Accessories
  5. 12297
  6. Assembly instructions manual

Original Tractor Cabs 12297 Assembly Instructions Manual

Cab for kubota lx 10 series
Hide thumbs

Advertisement

Quick Links

Download this manual
YESTERDAY
TODAY
Cab #12297 for Kubota LX 10 Series
PARTS LIST – ASSEMBLY INSTRUCTIONS
IMPORTANT!
READ THIS MANUAL CAREFULLY AND KEEP FOR FUTURE REFERENCE
CAUTION!
REMOVE THE VINYL PANELS FOR TRANSPORT IN AN OPEN TRUCK OR
TRAILER
WARNING
THIS CAB WILL NOT PROTECT OPERATOR FROM INJURIES CAUSED BY ROLLOVER,
COLLISION, OR OTHER ACCIDENTS
Go to our YouTube Channel and watch the Installation Video.
122970322
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the 12297 and is the answer not in the manual?

Questions and answers

Related Manuals for Original Tractor Cabs 12297

Summary of Contents for Original Tractor Cabs 12297

  • Page 1 YESTERDAY TODAY Cab #12297 for Kubota LX 10 Series PARTS LIST – ASSEMBLY INSTRUCTIONS IMPORTANT! READ THIS MANUAL CAREFULLY AND KEEP FOR FUTURE REFERENCE CAUTION! REMOVE THE VINYL PANELS FOR TRANSPORT IN AN OPEN TRUCK OR TRAILER WARNING THIS CAB WILL NOT PROTECT OPERATOR FROM INJURIES CAUSED BY ROLLOVER, COLLISION, OR OTHER ACCIDENTS Go to our YouTube Channel and watch the Installation Video.
  • Page 2 LIMITED WARRANTY SNOW REMOVAL EQUIPMENT CABS COVERED BY WARRANTY ORIGINAL TRACTOR CAB CO., INC., (the "Company") warrants to the owner that each new product listed below is merchantable and free of defects in workmanship and material. During the warranty period, the dealer from whom the product was bought, or the Company, will provide, free of charge, parts and the shipping costs of parts necessary to correct any defect in workmanship and material.

  • Page 3: Maintenance Instructions

    WARNING This cab is designed to provide foul weather protection only. It does not provide protection from noise, exhaust fumes, chemicals or injury from roll-over, collision, or other accidents. 1. Do not operate machine in confined areas without proper ventilation. 2.
  • Page 4 Carton Contents: Cab #12297 for Kubota LX 10 series Key # Part # Qty. Description 12298 Foot, RH 12299 Foot, LH 12300 Front Panel Frame 10926 Front Post, Long, RH 40148 Front Post, Short, LH 10002 Top Frame Brace, RH...
  • Page 5 Tools Required: 7/16” Socket and Wrench 9/16” Socket and Wrench 12mm Socket 13mm Socket and Wrench Needle Nose Pliers ¼” x ¾” ¼” x 1” M8-1.25 x 25mm ¼” x 5/8” 3/8” x 2-1/4” 5/16” Flat Washer 3/8” Flat Washer Vinyl Cap ½”...
  • Page 6 Step 1; See Figure 1: Use the parts list and Figure 1 to identify the steel parts.
  • Page 7 Step 2; See Figure 2, 2A and 2B: Install Right Foot (1) A. Remove the bolt at Reference A with a 9/16” Socket. B. Place the Foot as shown in Figure 2A and reinsert the bolt, fully tighten. Figure 2B Figure 2 Figure 2A...
  • Page 8 Step 3; See Figure 3, 3A, 3B and 3C Install Left Foot (2) A. Pull back the rubber mat from around the brake pedals. B. Remove the two bolts at Reference C. Place the Foot over the holes as shown in Figure 3A then install two M8 x 25mm bolts, each with a 5/16”...
  • Page 9 Step 4; See Figure 4, 4A, 4B and 4C Install Front Panel Frame (3) A. Under the left-hand step plate, remove the nut shown in Reference A. B. Place the left foot of the Front Panel Frame over the bolt as shown in Figure 4A and replace the nut, hand tighten.
  • Page 10 Step 5; See Figure 5, 5A and 5B: Install Front Post (4) and Top Frame Brace (6) Note: Bent ends of Top Frame Braces will point rearwards and lay flat when properly installed. Note: If you are installing the safety glass windshield omit Top Frame Braces.
  • Page 11 Step 6; See Figure 6, 6A and 6B Install Front Post (5) and Top Frame Brace (7) Note: Bent ends of Top Frame Braces will point rearwards and lay flat when properly installed. Note: If you are installing the safety glass windshield omit Top Frame Braces.
  • Page 12 Step 7; See Figure 7, 7A and 7B: Install ROPS Bracket RH (8), ROPS Bracket LH (9) and Rear Curtain Support (14) A. Place the ROPS Bracket RH over the lower set of bolt holes on the inside of the ROPS shown in Figure 7. B.
  • Page 13 Step 8; See Figure 8: Install the Top Frame (21) Note: The front of the Top Frame has the “L” tabs located closest to the corners. A. Place The rear half of the Top Frame onto the bent ends of the ROPS Brackets.
  • Page 14 Step 9; See Figure 9, 9A, 9B and 9C: Install Rear Post RH (10), Vinyl Stay (12) and Side Panel Support (13). A. Insert a ¼” x 5/8” bolt up through the Rear Post and the Top Frame. Add a nylock nut, do not fully tighten.
  • Page 15 Step 10; See Figure 10, 10A and 10B: Install Rear Post LH (11) and Vinyl Stay (12) Note: Only Rear Post LH (12) has a door latch. A. Insert a ¼” x 5/8” bolt up through the Rear Post and the Top Frame. Add a nylock nut, do not fully tighten.
  • Page 16 Step 11; See Figure 11 Install the Door for Frame/Door alignment. A. Follow the instructions in the Door Hardware Package to install the Door Bottom and the Door Latch. B. Install, close and latch the Door. C. Tighten all bolts from previous steps at this time.
  • Page 17 Step 12; See Figure 12, 12A, 12B and 12C: Install Windshield (15) and Front Panel Vinyl (16). A. Place the Windshield and Front Panel Vinyl face up on a clean flat surface. Align the pieces and press the Velcro together. B.
  • Page 18 Step 13; See Figure 13, 13A and 13B: Install Rear Curtain (17) A. Press the Velcro together around the top frame at the back and corners. B. Press the Velcro together over the Rear Posts and Vinyl Stays. C. Attach springs to holes shown in Figure 13B.
  • Page 19 Step 14; See Figure 14, 14A and 14B: Install Side Panel Vinyl (18) A. Press the Velcro together over the Top Frame. B. Press the Velcro together around the Front Post. C. Connect the Windshield and Front Panel Vinyl to the Side Panel. D.
  • Page 20 Step 15; See Figure 15 and 15A: Install Door and Top (22) A. Install the door and connect the Velcro on the lower door and front panel. B. Make sure that the rod sewn into the windshield is lying over the top frame. Place the top over the top frame.
  • Page 21 Optional Cab Accessories: #10120 Safety Glass Windshield #10122 Electric Wiper #12188 Low Profile LED Strobe Light #11133 Rear View Mirror, R or L #12142 Front LED Work Light Kit #12143 Rear LED Light Kit #12221 Convex RV Mirror For Replacement Parts and Accessories Contact: Original Tractor Cab Co., Inc.