Table of Contents
Advertisement
6.
DO NOT operate the appliance if water leaks from the unit,
maintenance will be required before the appliance can be safely
used.
7.
DO NOT allow the appliance to be run dry.
8.
DO NOT fit any form of outlet flow control. Only shower fittings
recommended by the manufacturer should be used.
9.
There are no user serviceable components beneath the cover of
the appliance. Only a competent tradesperson should remove the
cover.
10. Isolate the electricity and water supplies and refer to "To contact
us", on the back page of this guide, if any of the following conditions
occur:
The cover is not correctly fitted and water has entered the case.
The case is damaged.
The appliance begins to make an odd noise, smell or smoke.
The appliance shows signs of a distinct change in performance,
indicating a need for maintenance.
The appliance is frozen.
11. Turn off the electrical and water supplies before removing the
cover. The electricity must be turned off at the mains and, if
applicable, the appropriate circuit fuse removed.
12. Mains connections are exposed when the cover is removed.
13. Moving parts are exposed when the cover is removed.
14. Ensure all electrical connections are tight, to prevent overheating.
CAUTION!
1.
Read all of these instructions and retain this guide for later
use.
2.
Pass on this guide in the event of change of ownership of the
installation site.
3.
Follow all warnings, cautions and instructions contained in this
guide.
4.
Follow all warnings, cautions and instructions contained on or
inside the appliance.
5.
The electrical installation must comply with the "Requirements for
Electrical Installations" commonly referred to as the IEE Wiring
Regulations, or any particular regulations and practices specified
4
Advertisement
Table of Contents
