Wickes AQUATRONIC POWER Product Manual page 20

Caution! When resistance is felt DO
NOT USE FORCE to turn the spindle
any further as this is the maximum
shower temperature obtainable with
the available hot water storage
temperature. FORCE will DAMAGE
the internal components.
6. Turn the temperature spindle until
the maximum water temperature
required is obtained.
⇒
Warmer
⇒
Cooler Turn spindle clockwise
7. Refit the temperature hub with the
pip on the temperature hub aligned
with the slot on the thermostatic
cartridge. Secure the temperature
hub with the retaining screw.
8. Refit the flow control knob in the
maximum flow position.
9. Refit the temperature indicator trim
and temperature control knob.
Caution! If resistance is felt when
turning the temperature knob DO NOT
USE FORCE to turn the knob any
further as this will DAMAGE internal
components.
10. Check the temperature control can
fully turn in both directions.
11. Check the maximum temperature
setting. If necessary repeat the
temperature adjustment until the
correct setting is achieved.
Turn spindle anticlockwise
Maximum
Flow Position
Inner
Temperature
Control
20
Temperature
Spindle
Align the pip on the temperature
hub with the slot in the
thermostatic cartridge.
Temperature
Indicator
Trim
4
4