Table of Contents
Advertisement
Warning! Do not insert fingers into
the push-fit connectors as this can
result in injury.
Caution! Thoroughly flush the
incoming hot and cold water
supply pipes to remove debris
before connecting the shower unit.
13. Locate the shower unit on the inlet
supplies and push the inlet
manifold onto the pipework until
resistance is felt.
DO NOT FORCE!
Note! PTFE tape or liquid jointing
is
not required to assist
connection.
14. The inlet manifold collet and 'O'
seals will seal automatically.
Warning! The shower unit must
be fixed to the wall at all three
fixing points. The fixing holes are
elongated to assist in vertical and
horizontal alignment.
15. Screw the shower unit to the wall
using either the wall screws
supplied or alternative fixings
depending on the wall structure.
Do not over tighten!
Ensure that the electrical supply
cable is correctly seated in the
channel in the back of the case.
16
Advertisement
Table of Contents
