Wickes AQUATRONIC POWER Product Manual page 13

below the minimum clearance gap
between the bath or shower tray
spillover level of 25 mm.
2. Fit the three rubber feet into the
recesses on the case as shown.
The feet will reduce the noise
transmitted by the power shower
through the wall.
Warning! Blanking plates should
be fitted to stop access to the
inside of the unit.
3. Fit the blanking plates to the unit
case in the following manner.
For Top Inlet Pipework
For Rear Inlet Pipework
For Bottom Inlet Pipework
Fit the half blanking
plate to the top of
the case.
Fit the full blanking
plate to the bottom
of the case.
Fit the full blanking
plates to the top and
bottom of the case.
Fit the full blanking
plate to the top of
the case.
Fit the half blanking
plate to the bottom
of the case.
13
Rubber
Feet