Table of Contents
Advertisement
3.10 Pack&Go
After use, the product can be packed as follows:
1. Ensure that no‐one is lying on the mattress.
2. On the main menu, press
right hand corner. This takes you to the
Information menu from which the Deflation
function can be activated
3. Confirm by pressing
4. The function button will flash orange during
deflation. The mattress will empty of air and be
ready to be simply folded together within 20
minutes. The control unit gives an audio signal
once deflation is complete.
5. Carefully fold the mattress together, place
the control unit between the folds of the
mattress and place in a transportation bag
(accessory) or equivalent for protective storage.
Ensure that the power adaptor is packed away.
After Pack&Go has been completed, the system
returns to factory settings.
3.11 Restart
If a restart is required, set the On/Off switch on
the side of the control unit to position 0 (Off).
Wait approximately 10 seconds and restart the
control unit.
3.12 Battery indicator
If the control unit has been fitted with a backup
battery (variant), the condition of the battery is
shown as follows:
Battery 100%
Battery 75%
Battery 50%
Battery <25%
Charge immediately (control unit
prepares constant low pressure
therapeutic mode)
Battery charging
in the top
.
9
Note:
To ensure optimum function and condition, the
backup battery should never be discharged
completely. The battery charges up when the
control unit is operating. A fully charged battery
lasts for at least five hours.
If the control unit is left without operating for a
long period, the backup battery should be
charged every six months for maintenance
purposes.
3.13 Information
Button that takes you to the information menu.
In the information menu you will find:
•
Information about the product
•
Contact information for Care of Sweden
•
Shortcut to quick tour
•
Deflation function
3.14 Notifications
Notifications are shown with a warning triangle
on the main menu, with a dedicated display
image, or with a sound and flashing orange light
in the function button on the front.
Notifications are silenced and acknowledged
(disabled) using the function button on the
front. If problems occur with Notifications, see
section 8 for Troubleshooting.
Different notifications exist based on how
serious the warning is (Major or Silent
notification)
Major notification:
The error is of great significance for operation
or function and the control unit will indicate an
error by notifying with information on the
display, light and sound. After 10 min, the
frequency of how often the notification sound is
reduced if it is not acknowledged. Information
on the type of error is shown in the display, see
noitification types below
Advertisement
Table of Contents
