STEP 2 – Support Leg
•
Position the support leg so the J-shaped end is pointing away from the wheel assembly.
•
Insert the M8x75 hex bolt through the top hole on the support leg and slide the spacer over the bolt end.
•
Take the support leg and insert the bolt through the upper cross bar on the mounting assembly and
loosely tighten with the M8 lock nut.
NOTE: Before tightening the bolt make sure the support leg flange and the lower cross bar holes line up.
•
Insert M6 x 40 hex bolt through the holes in the flange and cross bar. Use the Ø6 big flat washer and M6
lock nut.
Cross Bar
Flange