STEP 3 - Hopper
•
Lower the hopper over the mounting assembly, carefully line up the holes in the bottom of the hopper
with the spindle in the mounting plate of the axle.
•
Use the M6 x 40 hex bolt and Ø6 flat washer to attach the hopper to the mounting assembly and secure
with M6 lock nut.
•
Make sure the gear and pinion gear works smoothly. If not, adjust again until the gear and pinion gear
swivel smoothly.
•
Tighten all the hardware on the shaft support plate and hopper.
•
Insert the R Pin through the top of the spindle.